Current subsystem, Current:static:recall – GW Instek PEL-2000 Series Programming User Manual User Manual
Page 56
PEL-2000 Programming Manual
56
Current Subsystem
:CURRent:STATic:RECall ............................................... 56
:CURRent:STATic:L1/L2 ................................................ 57
:CURRent:STATic:RISE/FALL ....................................... 58
:CURRent:STATic:LOW:AVALue/BVALue ................... 59
:CURRent:STATic:LOW:RISE/FALL ............................. 60
:CURRent:STATic:HIGH:AVALue/BVALue ................. 60
:CURRent:STATic:HIGH:RISE/FALL ............................ 61
:CURRent:DYNamic:L1/L2 ........................................... 62
:CURRent:DYNamic:RISE/FALL .................................. 63
:CURRent:DYNamic:T1/T2 ........................................... 64
:CURRent:DYNamic:LOW:L1/L2 ................................. 65
:CURRent:DYNamic:LOW:RISE/FALL ......................... 66
:CURRent:DYNamic:LOW:T1/T2 ................................. 67
:CURRent:DYNamic:HIGH:L1/L2 ............................... 67
:CURRent:DYNamic:HIGH:RISE/FALL ....................... 68
:CURRent:DYNamic:HIGH:T1/T2 ............................... 69
:CURRent:STATic:RECall
Channel Specific
Command
Description
Sets or queries whether A Value or B Value is the
currently active value in CC static mode.
Syntax
:CURRent:STATic:RECall {A|0|B|1}
Parameter
A/0
A
B/1
B
Example
:CURR:STAT:REC 1
Makes B Value the active
value.
Query Syntax
:CURRent:STATic:RECall?
Return Parameter
Value
0
A
1
B