GW Instek PEL-2000 Series Programming User Manual - Manual (Page 80)

PEL-2000 Programming Manual
80
Measure Subsystem
:MEASure:VOLTage? ..................................................... 80
:MEASure:CURRent? ..................................................... 80
:MEASure:POWer? ........................................................ 81
:MEASure:INPut ............................................................ 81
:MEASure:SCAN ............................................................ 82
:MEASure:ALLVoltage? ................................................. 82
:MEASure:ALLCurrent? ................................................. 83
:MEASure:ALLPower? .................................................... 83
:MEASure:VOLTage?
Channel Specific
Command
Description This query returns the measured voltage of the
specific channel.
Query Syntax :MEASure:VOLTage?
Return Parameter 1 unit = 1 volt Voltage at the load input
0.5000 0.5000 volts
Query Example :MEAS:VOLT?
8.5600 A voltage of 8.56 volts is
measured at the specific
channel load input.
:MEASure:CURRent?
Channel Specific
Command
Description This query returns the measured current of the
specific channel.
Query Syntax :MEASure:CURRent?
Return Parameter 1 unit = 1 amp Current at the load input
1.0000 1.0000 amps
Query Example :MEAS:CURR?
1.5 A current of 1.5 amps is
measured at the specific
channel load input.