GW Instek PEL-2000 Series Programming User Manual - Manual (Page 87)

COMMAND DETAILS
87
OCP Test Automation Commands
:OCP:EDIT:CHANnel? ................................................... 87
:OCP:CHANnel:RANGe ................................................. 88
:OCP:CHANnel:STARt ................................................... 88
:OCP:CHANnel:END ...................................................... 89
:OCP:CHANnel:STEP:CURRent .................................... 89
:OCP:CHANnel:LAST ..................................................... 90
:OCP:CHANnel:STEP:TIME .......................................... 90
:OCP:CHANnel:DELay ................................................... 91
:OCP:CHANnel:TRIGger ................................................ 91
:OCP:CHANnel:ACTive .................................................. 92
:OCP:STATus?................................................................. 92
:OCP:SAVE ...................................................................... 93
:OCP:RESult? .................................................................. 93
:OCP:RUN ....................................................................... 93
:OCP:EDIT:CHANnel?
Channel Specific
Command
Description Sets or queries which channel is used to apply the
OCP Test Automation parameters. Also see page
92 for setting the active channel.
Syntax :OCP:EDIT:CHANnel
Parameter 1-8
Example :OCP:EDIT:CHAN 1 Sets channel 1 as the
chosen channel.
Query Syntax :OCP:EDIT:CHANnel?
Return Parameter 1-8
Query Example :OCP:EDIT:CHAN?
1 Channel 1 is the chosen
channel.