GW Instek PEL-2000 Series Programming User Manual - Manual (Page 120)

PEL-2000 Programming Manual
120
:SPECification:VOLTage:H/L/C
Channel Specific
Command
Description Sets the high(H), low(L) and center(C) Go/NoGo
voltage limit specifications. Applicable to CC and
CR mode only.
Syntax :SPECification:VOLTage:H/L/C [V]
Parameter [V] 1 unit = 1 volt Go/NoGo voltage limit
1 1 volt
1V 1 volt
Example :SPEC:VOLT:H 2V Sets the Go/NoGo high
voltage limit to 2 volts.
Query Syntax :SPECification:VOLTage:H/L/C?
Return Parameter Go/NoGo voltage
1 unit = 1 volt Returns the limit voltage
Query Example :SPEC:VOLT:H?
2.000 The voltage limit is 2
volts.
:SPECification:CURRent:H/L/C
Channel Specific
Command
Description Sets the high(H), low(L) and center(C) Go/NoGo
current limit specifications. Applicable to CV
mode only.
Syntax :SPECification:CURRent::H/L/C [A]
Parameter [A] 1 unit = 1 amp Go/NoGo current limit
1 1 amp
1A 1 amp
Example :SPEC:CURR:H 1A Sets the Go/NoGo high
current limit to 1 amp.
Query Syntax :SPECification:CURRent:H/L/C?