GW Instek PEL-2000 Series Programming User Manual - Manual (Page 103)

COMMAND DETAILS
103
Resistance Subsystem
:RESistance[:STATic]:L1/L2 ......................................... 103
:RESistance[:STATic]:RISE/FALL ................................. 104
:RESistance:STATic:RECall .......................................... 105
:RESistance:STATic:LOW:AVALue/BVALue .............. 105
:RESistance:STATic:LOW:RISE/FALL ......................... 106
:RESistance:STATic:HIGH:AVALue/BVALue ............. 107
:RESistance:STATic:HIGH:RISE/FALL ....................... 108
:RESistance:DYNamic:LOW:L1/L2 ............................. 109
:RESistance:DYNamic:LOW:RISE/FALL .................... 110
:RESistance:DYNamic:LOW:T1/T2 ............................ 110
:RESistance:DYNamic:HIGH:L1/L2 ........................... 111
:RESistance:DYNamic:HIGH:RISE/FALL .................. 112
:RESistance:DYNamic:HIGH:T1/T2 ........................... 113
:RESistance[:STATic]:L1/L2
Channel Specific
Command
Description Sets A/B Value for constant resistance mode,
where L1 is A Value and L2 is B Value. This
command only applies to current mode (static).
Syntax :RESistance[:STATic]:L1/L2 [OHM]
Parameter NRf+[OHM] Resistance
L1 10 Sets A Value to 10 ohms
L2 20 Sets B Value* to 20 ohms
*Single Channel
L1 MIN Sets A Value to the
minimum level for the
specific channel.
L1 MAX Sets A Value to the
maximum level for the
specific channel.