Command details, Ommand details – GW Instek PEL-2000 Series Programming User Manual User Manual
Page 24

PEL-2000 Programming Manual
24
C
OMMAND DETAILS
The Command details chapter shows the detailed
syntax, equivalent panel operation, and example
for each command. For the list of all commands,
see page16. Before programming the PEL-2000
electronic load, please become familiar with the
Status registers, detailed on page162.
Common commands ................................ 26
Abort Subsystem ...................................... 32
Channel Subsystem .................................. 33
CONFIGURE Subsystem .......................... 38
Utility Subsystem ..................................... 51
Current Subsystem ................................... 56
FETCH Subsystem ................................... 71
LOAD Subsystem ..................................... 75
Measure Subsystem ................................. 80
MODE Subsystem .................................... 85
Program Subsystem ................................. 87
Resistance Subsystem ............................ 103
RUN Subsystem ..................................... 115
SHOW Subsystem .................................. 116
SPECIFICATION Subsystem ................... 118
STATUS Subsystem ................................ 122
Voltage Subsystem ................................. 130
Power Subsystem ................................... 135
SYSTEM Subsystem ............................... 141
Memory Subsystem ................................ 143
SEQuence Subsystem............................. 149
GLOBal Subsystem ................................ 159