IBM SC30-3865-04 - Manual (Page 92)

Non-Responding addresses:
Retries = 1
Timeout = 0 seconds
Call timeouts:
Command Delay = 0 ms
Connect = 60 seconds
Disconnect = 2 seconds
Cable type = RS-232 DTE
Speed (bps) = 9600
V25bis Config>
Note:
1 A non-zero value for Idle Timer results in a dial-on-demand link
2 A zero value results in a leased link
Configuring V.34
The following is a sample V.34 configuration that could be used when APPN traffic
uses PPP over V.34:
Config> list device
Ifc 0 Token Ring CSR 6000000, vector 28
Ifc 1 WAN PPP CSR 81620, CSR2 80D00, vector 93
Ifc 2 WAN PPP CSR 81640, CSR2 80E00, vector 92
Config>set data v34 2.
Config>list device
Ifc 0 Token Ring CSR 6000000, vector 28
Ifc 1 WAN PPP CSR 81620, CSR2 80D00, vector 93
Ifc 2 V.34 Base Net CSR 81640, CSR2 80E00, vector 92
Config>add v34
Assign address name [1-23] chars []? brown
Assign network dial address [1-30 digits] []? 555-1211
Config>add v34
Assign address name [1-23] chars []? gray
Assign network dial address [1-30 digits] []? 555-1212
Config>list v34
Address assigned name Network Address
--------------------- ---------------
default_address 9999999
brown 555-1211
gray 555-1212
Config>add device dial
Adding device as interface 3
Defaulting Data-link protocol to PPP
Use "net 3" command to configure circuit parameters
Config>net 3
Circuit configuration
Circuit config: 3>list all.
Base net = 0
Destination name =
Circuit priority = 8
Outbound calls = allowed
Inbound calls = allowed
Idle timer = 60 sec
SelfTest Delay Timer = 150 ms
Circuit config: 3>set net
Base net for this circuit [0]? 2
Circuit config: 3>set idle 0
Circuit config: 3>set dest
Assign destination address name []? brown
Circuit config:
3>list all
Base net = 2
Destination name = brown
Circuit priority = 8
Destination address: subaddress = 555-1211
APPN
62 MRS V3.2 Protocol Config Ref Vol 2