IBM SC30-3865-04 - Manual (Page 461)

RIP6 output Metric
Specifies the value of the metric used on outgoing RIP6 updates.
Valid Values: 0 - 15
Default Value: 0
Accessing the RIP6 Monitoring Environment
Use the following procedure to access the RIP6 monitoring commands. This
process gives you access to the RIP6 monitoring process.
1. At the OPCON prompt, enter talk 5. (For more detail on this command, refer to
“The OPCON Process” in Software User’s Guide.) For example:
* talk 5
+
After you enter the talk 5 command, the GWCON prompt ( + ) displays on the
terminal. If the prompt does not appear when you first enter configuration, press
Return again.
2. At the + prompt, enter the p rip6 command to get you to the RIP6> prompt.
Example:
+ p rip6
RIP6>
RIP6 Monitoring Commands
This section describes the RIP6 monitoring commands.
Table 74. RIP6 Monitoring Command Summary
Command Function
? (Help) Displays all the commands available for this command level or lists the
options for specific commands (if available). See “Getting Help” on page
xxvi.
list Displays the configuration.
dump Displays routing tables.
ping6 Dynamically pings an IPv6 address.
Exit Returns you to the previous command level. See “Exiting a Lower Level
Environment” on page xxvii.
List
Use the list command to display the configuration.
Syntax:
list
Example:
RIP6>list
Dump
See “Dump routing tables” on page 416 for information about the dump command.
RIP6 Configuration Commands (Talk 6)
Chapter 17. Configuring and Monitoring Routing Information Protocol (RIP6) 431
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
||
||
|
|
||
||
||
||
|
|
|
|
|
|
|
|
|