IBM SC30-3865-04 - Manual (Page 365)

hello PDU dropped, received over point-to-point circ 0
ESIS hello PPDU dropped, no matching area address 0
dropped hello packet - manual ES adjacency exists 0
ESIS input queue overflow
The ESIS packet was dropped because of a task input queue has
overflowed.
Received incomplete packet
A packet fragment recognized as an ESIS packet was received.
Received packet with bad checksum
An ESIS packet with a bad checksum was received.
Received packet with bad version
An ESIS packet with a bad or unsupported version was received.
Received packet with bad type
An ESIS packet with a bad or unsupported type field was received.
No iob available to send hello
An attempt to send an ESIS hello failed because of a lack of system I/O
buffers.
Cannot send hello due to packet handler error
An ESIS hello could not be sent because of a handler error.
Sent hello
An ESIS hello was sent out an interface.
Received packet with bad header
An ESIS hello packet with a bad holding time or received field was
received.
Received hello with nsap
An ESIS hello packet with a bad NSAP or an NSAP that over ran the field
was received.
Received hello packet with bad option
An ESIS CLNP data packet was received with a bad option parameter.
Received hello
An ESIS hello packet was received on the interface.
Received hello with unsupported domain source
An ESIS hello packet was received from an unspecified domain source.
No resources to install route
An ESIS hello packet was received, but there were no resources to install
the route.
Received hello with conflicting route
An ESIS hello packet was received but could not be entered into the
database. A previously-defined static or dynamic route in the database
conflicts with the route in the hello.
Timed out route reactivated
An ESIS hello packet with a previously timed out route was received.
No resources to send redirect
An ESIS redirect packet could not sent because of a lack of resources.
Redirect not sent handler error
An ESIS redirect packet could not be sent because of a handler error.
OSI/DECnet V Monitoring Commands (Talk 5)
Chapter 10. Configuring and Monitoring OSI/DECnet V 335