IBM SC30-3865-04 - Manual (Page 185)

Table 23. Configuration Parameter List - Link Station - Detail (continued)
Parameter Information
Parameter
Use enhanced session security (If security is enabled)
Valid Values
Yes, No
Default Value
No
Parameter
High-performance routing (HPR) supported
Valid Values
Yes, No
Default Value
APPN network node, APPN end node or LEN end node: the value specified in the
default HPR supported parameter for this port All other adjacent node types: No
Description
This parameter indicates whether this link station supports HPR. The user should
disable HPR support if the underlying link is unreliable. An HPR connection will not be
established unless both link stations advertise HPR support during XID exchange.
Parameter
DLCI number for link (frame relay only)
Valid Values
16 to 1007
Default Value
16
Description
The DLCI parameter identifies the frame-relay logical data link connection with the
adjacent node.
Parameter
Station address of adjacent node (SDLC only)
Valid Values
Address in the range of (1 - FE)
Default Value
C1
Description
This parameter specifies the address of the adjacent node.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 155