IBM SC30-3865-04 - Manual (Page 125)

Table 7. Configuration Parameter List - Dependent LU Requester (continued)
Parameter Information
Parameter
Delay before initiating retries
Valid Values
0 to 2 756 000 seconds
Default Value
120 seconds
Description
This parameter specifies an amount of time for two different cases when the pipe
between the DLUR and its DLUS is broken.
v For the case of receiving a non-disruptive UNBIND:
This parameter specifies the amount of time the DLUR must wait before
attempting to reach the primary DLUS.
A value of 0 indicates immediate retry by the DLUR.
v For all other cases of pipe failure:
The DLUR will try the primary DLUS and then the backup DLUS immediately. If
this fails, DLUR will wait for the amount of time specified by the minimum of the
short retry timer and this parameter before attempting to reach the primary
DLUS.
See “DLUR Retry Algorithm” on page 41 for a complete description of the retry
algorithm.
Parameter
Perform short retries to restore disrupted pipe
Valid Values
Yes, No
Default Value
If Perform retries to restore disrupted pipes is Yes, then the default value is Yes.
Otherwise, the default is No.
Description
See “DLUR Retry Algorithm” on page 41 for a complete description of the retry
algorithm.
Parameter
Short retry timer
Valid Values
0 to 2 756 000 seconds
Default Value
120 seconds
Description
In all cases of pipe failure other than non-disruptive UNBIND, the minimum of Delay
before initiating retries and this parameter specifies the amount of time DLUR will wait
before attempting to reach the primary DLUS after an attempt to establish this
connection has failed.
See “DLUR Retry Algorithm” on page 41 for a complete description of the retry
algorithm.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 95