IBM SC30-3865-04 - Manual (Page 435)

Chapter 15. Configuring and Monitoring Neighbor Discovery
Protocol (NDP)
Configuration for NDP is done for each interface. This chapter describes how to use
the NDP configuration and operating commands and includes the following
sections:
v “Accessing the NDP Configuration Environment”
v “NDP Configuration Commands”
v “Accessing the NDP Monitoring Environment” on page 409
v “NDP Monitoring Commands” on page 410
Accessing the NDP Configuration Environment
Use the following procedure to access the NDP configuration process.
1. At the OPCON prompt, enter talk 6. (For more detail on this command, refer to
The OPCON Process and Commands in the Software User’s Guide.) For
example:
* talk 6
Config>
After you enter the talk 6 command, the CONFIG prompt ( Config> ) displays on
the terminal. If the prompt does not appear when you first enter configuration,
press Return again.
2. At the CONFIG prompt, enter the p ndp command to get to the NDP6 Config>
prompt.
NDP Configuration Commands
To configure NDP, enter the commands at the NDP6 Config> prompt.
Table 69. NDP Configuration Command Summary
Command Function
? (Help) Displays all the commands available for this command level or lists the
options for specific commands (if available). See “Getting Help” on page
xxvi.
add Adds a router advertisement or parameters.
change Changes a router advertisement or parameters.
delete Deletes a router advertisement or parameters.
disable Disables router advertisement.
enable Enables router advertisement.
list Lists the configuration.
Exit Returns you to the previous command level. See “Exiting a Lower Level
Environment” on page xxvii.
Add
Use the add command to add a router advertisement.
add ra ...
© Copyright IBM Corp. 1994, 1998 405
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
||
||
|
|
||
||
||
||
||
||
||
|
|
|
||