IBM SC30-3865-04 - Manual (Page 351)

Type Indicates whether the circuit is STATIC-IN, STATIC-OUT, or DA (dynamically
allocated).
Direction
Indicates how the router establishes a static routing circuit: by an incoming
call request (IN) or an outgoing call request (OUT).
In either case, the SVC is initially established upon operator action, but the
circuit is not fully enabled until both ends of the circuit have initialized
successfully.
Initial Min Timer
The amount of time (in seconds) that a static-out circuit waits for a link to
be initialized (reception of either an ESH or an ISH) after the call request
has been accepted. If the initial min timer expires before the link is fully
initialized, the SVC is cleared and an event is generated indicating
initialization failure.
Enable IS-IS
Indicates whether the IS-IS protocol is enabled on this circuit.
L2 Only
Indicates whether this routing circuit is used for Level2 routing only.
External Domain
Indicates whether the router transmits and receives messages to and from
a domain outside its IS-IS routing domain.
Metric Gives the cost of this address.
ISIS Hello Timer
Gives the time interval between transmissions of ISIS hellos.
DECnetV Link Initialization
Indicates whether DEC-style link initialization for this circuit is enabled
(YES) or disabled (NO).
Receive Verifier
Displays verification data to be checked against a received XID when
verifying by circuit.
Transmit Verifier
Displays verification data to be included in XIDs when verifying by circuit.
Explicit Receive Verification
Indicates whether verification is done by the circuit or the system. TRUE
indicates verification by the circuit, FALSE indicates verification by the
system.
Subnet subnet.reprt intfc#
Displays subnet information.
v Subnet.reprt has two options, Summary and Detailed.
– Summary displays information for all configured subnets.
– Detailed displays information for LAN subnets only.
v Intfc# is the interface that connects to the subnet.
Example:
list subnet summary
Ifc State Type ESIS ISIS L2 Only Ext Dom Metric EIH (sec) IIH(sec)
0 On LAN Enb Enb False False 20 10 3
2 On X25
3 On Frl
DECnet V/OSI Configuration Commands (Talk 6)
Chapter 10. Configuring and Monitoring OSI/DECnet V 321