IBM SC30-3865-04 - Manual (Page 182)

Table 23. Configuration Parameter List - Link Station - Detail (continued)
Parameter Information
Parameter
IP address of adjacent node
Valid Values
Any valid IP address
Default Value
none
Description
Each link on the HPR/IP port must have a unique destination IP address.
Parameter
Adjacent node type
Valid Values
APPN network node, APPN end node, LEN end node
Default Value
APPN network node
Description
This parameter identifies whether the adjacent node is an APPN node, a low-entry
networking (LEN) end node.
When APPN end node is selected and Limited resource is No, APPN changes the
adjacent node type internally to learn and will work with any node type.
When APPN end node is selected and Limited resource is Yes, the adjacent node type
is unchanged.
When you select LEN end node , the fully-qualified control point name parameter is a
required parameter. If this network node is communicating with the IBM Virtual
Telecommunications Access Method (VTAM) product through the LEN node, and the
LEN node is not a T2.1 node or does not have an explicitly defined control point (CP)
name, then the router network node’s XID number for the Subarea connection
parameter also must be specified to establish a connection.
Note:
LEN end node is not a valid node type for HPR/IP interface.
APPN Configuration Commands
152 MRS V3.2 Protocol Config Ref Vol 2