IBM SC30-3865-04 - Manual (Page 347)

Example:
disable subnet 0
Enable
Use the enable command to enable the OSI protocol or an OSI subnet.
Syntax:
enable osi
routing-circuit...
subnet...
osi Enables the OSI protocol on the router.
routing-circuit routing-circuit-name
Enables the specified routing circuit.
Use the add routing-circuit command to set up routing-circuits.
Example:
enable routing-circuit p_system2
subnet interface#
Enables the OSI protocol on the specified subnet ( interface#).
Example:
enable subnet 0
List
Use the list command to display the current configuration of the OSI protocol.
Syntax:
list adjacencies
algorithm
alias
filter (DEC configuration only)
globals
password
phaseivpfx
prefix-address
routing-circuits (DEC configuration only)
subnets
templates (DEC configuration only)
timers
virtual-circuits
adjacencies
Displays all statically configured ES adjacencies.
Example:
DECnet V/OSI Configuration Commands (Talk 6)
Chapter 10. Configuring and Monitoring OSI/DECnet V 317