IBM SC30-3865-04 - Manual (Page 197)

Table 25. Configuration Parameter List - Modify TG Characteristics (continued)
Parameter Information
Parameter
Effective capacity
Valid Values
2 hexadecimal digits in the range X'00' to X'FF'
Default Value
Default value is taken from the associated port parameter.
Description
This parameter specifies the maximum bit transmission rate for both physical links and
logical links. Note that the effective capacity for a logical link may be less than the
physical link speed.
The effective capacity is encoded as a single-byte representation. The values X'00' and
X'FF' are special cases used to denote minimum and maximum capacities. The range
of the encoding is very large; however, only 256 values in the range may be specified.
Parameter
First user-defined TG characteristic
Valid Values
0 to 255
Default Value
Default value is taken from the associated port parameter.
Description
This parameter specifies the first of three additional characteristics that users can
define to describe the TGs in a network.
Parameter
Second user-defined TG characteristic
Valid Values
0 to 255
Default Value
Default value is taken from the associated port parameter.
Description
This parameter specifies the second of three additional characteristics that users can
define to describe the TGs in a network.
Parameter
Third user-defined TG characteristic
Valid Values
0 to 255
Default Value
Default value is taken from the associated port parameter.
Description
This parameter specifies the third of three additional characteristics that users can
define to describe the TGs in a network.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 167