IBM SC30-3865-04 - Manual (Page 436)

Example:
NDP config>add ra
ra Adds a router advertisement.
add router advertisement on which interface
Specifies the interface to which the router advertisement is to be
added.
Valid Values: A numeric value identifying a network interface
Default Value: 0
Managed address configuration (stateful)
Specifies whether hosts use the administered protocol for address
autoconfiguration in addition to addresses autoconfigured using
stateless autoconfiguration.
Valid Values: yes or no
Default Value: n
Other stateful configuration
Specifies whether hosts use the administered protocol for
autoconfiguration of other (non-address) information.
Valid Values: yes or no
Default Value: no
Include link layer address with router advertisement
Specifies whether to include the link layer address in the router
advertisement. A router may omit the link layer address in the router
advertisement in order to enable inbound load sharing across
multiple link layer addresses.
Valid Values: yes or no
Default Value: yes
Hop limit
Specifies the default value to be placed in the hop limit field in the
router advertisement messages sent by the router. This value is
used in the hop count field of the IP header for outgoing IP packets.
Valid Values: 0 - 255, where 0 means unspecified by this router
Default Value: 0
Maximum router advertisement interval
Specifies the maximum time, in seconds, allowed between sending
unsolicited multicast router advertisements from the interface.
Valid Values: 4 - 1800 seconds
Default Value: 600
Minimum router advertisement interval
Specifies the minimum time, in seconds, allowed between sending
unsolicited multicast router advertisements from the interface.
Valid Values: 3 - (.75 * Maximum router advertisement interval)
Default Value: Maximum router advertisement interval/3
NDP Configuration Commands (Talk 6)
406 MRS V3.2 Protocol Config Ref Vol 2
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|