IBM SC30-3865-04 - Manual (Page 344)

Syntax:
clear receive-password
sram
transmit-password
receive-password
Removes all of the receive-passwords previously configured using the add
receive-password command.
Note: You will receive an error message if you use an invalid password
type.
Example:
clear receive
Password Type [Domain]:
Password Type
Specifies the type of password being used, Domain or Area. Refer
to the add receive-password command for description of these
passwords.
SRAM
Use this parameter to erase the OSI configuration from SRAM.
Attention: Use this command
only if you intend to erase the configuration.
Example:
clear sram
Warning: All OSI SRAM Information will be erased.
Do you want to continue? (Y/N) [N]?
Transmit-password
Removes the transmit-password previously configured using the
set transmit-password command. The output for this parameter is the
same as that of the receive-password parameter.
Note: You will receive an error message if you use an invalid password
type.
Example:
clear password transmit
Password Type [Domain]:
Delete
Use the delete command to remove parameters previously configured using the set
or add command.
Syntax:
delete adjacency
alias
area
filter (DEC configuration only)
prefix-address
routing-circuit
DECnet V/OSI Configuration Commands (Talk 6)
314 MRS V3.2 Protocol Config Ref Vol 2