IBM SC30-3865-04 - Manual (Page 150)

Table 14. Configuration Parameter List - Miscellaneous Traces (continued)
Parameter Information
Parameter
Length to trace
Valid Values
1 - 3600
Default Value
100
Description
This parameter specifies the number of bytes of trace data to accumulate.
Parameter
Trace Locates
Valid Values
Yes, No
Default Value
No
Description
If this parameter is enabled, the APPN trace facility will filter the trace data according to
locates.
Parameter
Trace TDUs
Valid Values
Yes, No
Default Value
No
Description
If this parameter is enabled, the APPN trace facility will filter the trace data according to
transmission data units.
Parameter
Trace route setups
Valid Values
Yes, No
Default Value
No
Description
If this parameter is enabled, the APPN trace facility will filter the trace data according to
route setups.
Parameter
Trace CP Capabilities
Valid Values
Yes, No
Default Value
No
Description
If this parameter is enabled, the APPN trace facility will filter the trace data according to
CP Capabilities.
APPN Configuration Commands
120 MRS V3.2 Protocol Config Ref Vol 2
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|