IBM SC30-3865-04 - Manual (Page 390)

Disable NHRP
Use the disable command to disable NHRP on all interfaces not explicitly defined
using an NHRP advanced config command.
Syntax:
disable nhrp
Example:
NHRP config> disable
Disable NHRP for the router [No]:
Advanced Config
Use the advanced command to get to the NHRP advanced configuration prompt,
NHRP Advanced config> . From this prompt, you can enter the commands described
in “NHRP Advanced Configuration Commands” on page 361.
Syntax:
advanced nhrp
Example:
NHRP config> advanced
NHRP Advanced config>
Note: Most installations will not need to use this “advanced” command. The enable
NHRP command is sufficient to enable NHRP with recommended default
options.
List
Use the list command to list the NHRP configuration.
Syntax:
list
Example:
NHRP config> list
Box level NHRP enabled
Explicit interface definitions override box level setting
Interfaces explicitly defined for NHRP
--------------------------------------
Interface 0: ATM
NHRP enabled
NHRP LANE Shortcut Interface:
--------------------------------------------------
Interface: 1 ESI: burned-in Sel: auto
Use Best Effort: no (Data)
Cell Rate(kbps): Peak: 155000 Sustained: 155000
ATM adapter's burned-in MAC address is used as source address
General Parameters
------------------
Holding time: 20 minutes
Protocol Access Controls: Use source and destination address
When should NHC attempt shortcuts?: Based on datarate
Data-rate threshold: 10 packets/second
NHRP Configuration Commands (Talk 6)
360 MRS V3.2 Protocol Config Ref Vol 2