IBM SC30-3865-04 - Manual (Page 218)

v Character data followed by Enter will replace the currently displayed
name with the new character data.
v 9 followed by Enter will jump to the end of the list where new names can
be appended.
v At the end of a list, Enter alone completes the list.
Table 37. Configuration Parameter List - Routing List Configuration
Parameter Information
Parameter
Routing list name
Valid Values
Character string up to 20 characters in length with no imbedded blanks. Mixed case
and special characters are allowed.
Default Value
Blank
Description
This parameter identifies a specific routing list for modification. listing, or deletion by the
configuration code. It is not used by the operational code. Up to 255 routing lists may
be configured depending upon availability of configuration memory. Case is respected.
Parameter
Subnet visit count
Valid Values
1 to 255
Default Value
Default taken from corresponding node level parameter
Description
This parameter specifies how many networks a locate search procedure may traverse.
Parameter
Dynamic routing list updates
Valid Values
0 (none)
1 (full)
2 (limited)
Default Value
Default value taken from corresponding node level parameter
Description
This parameter controls whether entries can be automatically added to the node’s
temporary subnet routing list. It can be set to the same values as the analogous node
level parameter. If this function is enabled the automatically added entries are only
added to the temporary copy of the routing list.
APPN Configuration Commands
188 MRS V3.2 Protocol Config Ref Vol 2