IBM SC30-3865-04 - Manual (Page 312)

maximum visits
Maximum number of routers a packet may be routed through
between source and destination.
physical address
Physical Ethernet address set on all Ethernet circuits when DNA
starts. Derived from the node ID.
routing version
Version is always Version 2.0.0.
state The state of DNA, on or off.
type Either ROUTING IV or AREA, corresponding to level 1 and level 2.
module access-control circuit-specifier argument
Lists the DECnet access control lists that have been defined in the
permanent database for the router, as well as the counters of their use. The
options for the circuit-specifiers include the following:
all circuits
Specifies all circuits on the router.
circuit [name]
Specifies the named circuit.
known circuits
Specifies all circuits on the router.
The following items are the arguments you select from after you enter the
show/list module access-control command and the circuit-specifier:
counters
Gives counters on the use of the access control lists.
status Shows detailed information on the access control lists, including the
filters in the access control list.
summary
Shows summary information on the state of the access control lists.
This is the default.
Example:
show module access-control circuit eth/0 counters
Example:
list module access-control circuit eth/0 counters
Module Access-Control Volatile Counters
Circuit = Eth/0
6337 Seconds since last zeroed
0 Packets processed
0 Packets rejected
0 Access control loop iterations
module routing-filter circuit-specifier argument
Lists the DECnet area routing filters that have been defined in the
permanent database for the router.
all circuits
Specifies all circuits on the router.
circuit [name]
Specifies the named circuit.
DNA IV Configuration and Monitoring Commands
282 MRS V3.2 Protocol Config Ref Vol 2