IBM SC30-3865-04 - Manual (Page 443)

variables
Displays configuration information about global PIM variables.
Example:
PIM config>list v
PIM Global Configuration Values
PIM: on
Graft Timeout: 3 seconds
Assert Timeout: 210 seconds
PIM config>
PIM: on/off
Identifies whether PIM is currently enabled or disabled.
Graft timeout
Identifies the number of seconds that grafts are retransmitted if no
graft acknowledgement has been received.
Assert timeout
Identifies the number of seconds that assert information learned by
upstream devices is retained before reverting back to local routing
information.
preference
Displays current configured routing type metric preferences.
Example:
PIM config>list p
RIP FFFF Default FFFF
Direct FFFF Fixed FFFF
Filter FFFF
PIM config>
Route type
Identifies the route type supported and lists a hexadecimal value
displaying the currently configured metric preference.
Set
Use the set command to change PIM configuration parameter values. You can use
this command to add a new physical interface.
Syntax:
set interface interfaceaddress helloperiod
joinpruneholdtime
preference routetype preferencevalue
variables
interface
Example:
PIM config>set interface
Interface address []?
Hello period [30]?
Join Prune Hold Time [210]?
Interface address
Valid Values: Any valid IPv6 address
PIM Configuration Commands (Talk 6)
Chapter 16. Configuring and Monitoring Protocol Independent Multicast Routing Protocol (PIM) 413
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
||
||
|
|
|
|
|
|
|
|