IBM SC30-3865-04 - Manual (Page 154)

Table 16. Configuration Parameter List - APPN ISR Recording Media (continued)
Parameter Information
Parameter
Memory buffers full
Valid Values
Stop recording (0), Wrap (1)
Default Value
Stop recording (0)
Description
This parameter specifies the action to take when the memory buffer allocated to store
intermediate session records becomes full. Select Stop recording to instruct the router
to discard any new intermediate session records. Select Wrap to allow new records to
overwrite existing records in the buffer. The oldest records in the buffer are overwritten
first.
Parameter
Memory record format
Valid Values
ASCII (0), Binary (1)
Default Value
ASCII (0)
Description
This parameter specifies the format in which intermediate session records are to be
stored in the router’s local memory.
Parameter
Time between database updates
Valid Values
60 — 1440 minutes
Default Value
60
Description
This parameter sets the time in minutes between topology database updates.
Note:
v When you enable the collection of intermediate session records, the data associated with
the records also is collected, by default, in SNMP
v MIB variables for APPN. The MIB variables are updated, in this case, whether or not the
Collect intermediate session information parameter (in Table 15 on page 121) has been
enabled.
v Intermediate session data can be stored in router memory.
Add
Use the add command to add or update:
Syntax:
add port
APPN Configuration Commands
124 MRS V3.2 Protocol Config Ref Vol 2