IBM SC30-3865-04 - Manual (Page 234)

Table 43. Configuration Parameter List - Add TN3270E Map (continued)
Parameter Information
Parameter
Client IP address or Network address Mask
Valid Values
Any valid IP address mask
Default Value
0.0.0.0
Description
This parameter specifies the IP address mask of the client or network map definition to
be added.
Parameter
Pool name/LU name
Valid Values
A string of 1 to 8 characters:
v First character: A to Z
v Second to eighth characters: A to Z, 0 to 9
Default Value
None
Description
This parameter specifies an LU name or a Pool name to be mapped to the IP address.
The LU name can only be mapped to a Host address. If the mask is a network mask,
the name specified must be a pool name.
Syntax:
add port
This command specifies additional port for the TN3270E Server to
listen on. You will be prompted to enter values for the following
parameters. The parameter range will be shown in parentheses ( ).
The parameter default will be shown in square brackets [ ].
Table 44. Configuration Parameter List - Add TN3270E Port
Parameter Information
Parameter
Port number
Valid Values
1 to 65536
Default Value
none
Description
This parameter specifies the port number to be added.
APPN Configuration Commands
204 MRS V3.2 Protocol Config Ref Vol 2
|
|
|
|
|
|
|
||
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
||
|
|
||
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|