IBM SC30-3865-04 - Manual (Page 186)

Table 23. Configuration Parameter List - Link Station - Detail (continued)
Parameter Information
Parameter
Limited Resource (PPP, X.25 FR over dial circuits, ATM)
Valid Values
Yes, or No
Default Value
No
If the link type is PPP or FR, the default will be taken from the limited resource
parameter for the associated port.
Description
This parameter specifies whether the TG for this link station is a limited resource. If you
answer
yes , then the Virtual Channel Type is SVC .
Parameter
Branch Uplink
Valid Values
Yes or No
Default Value
The value specified for Branch Uplink on the port.
Description
This parameter indicates whether this link will be a Branch uplink (to WAN) or Branch
downlink (to LAN).
This question is asked only if Enabled Branch Extender has been set to yes and if
this link station is not a network node. If Enabled Branch Extender has been set to
yes and this link station is a network node, then Branch Uplink defaults to yes
Parameter
Is uplink to another Branch Extender node
Valid Values
Yes or No
Default Value
No
Description
This parameter indicates whether or not the adjacent node has the Branch Extender
function enabled.
This question is asked only if Branch Extender is enabled on this node, this is an
uplink, and the uplink is a limited resource.
APPN Configuration Commands
156 MRS V3.2 Protocol Config Ref Vol 2