IBM SC30-3865-04 - Manual (Page 160)

Table 18. Configuration Parameter List - Port Configuration for ATM (continued)
Parameter Information
Parameter
ATM Network Type
Valid Values
Campus or Widearea
Default Value
Campus
Description
This parameter specifies the network type used for default values for connection
networks and other link stations defined on this port.
Parameter
Shareable connection network traffic
Valid Values
Yes, No
Default Value
No
Description
This parameter specifies whether connection network traffic can be routed on the ATM
VC set up for a link station on this port.
Parameter
Shareable other protocol traffic
Valid Values
Yes, No
Default Value
No
Description
This parameter specifies whether other higher level protocol traffic can be routed on the
ATM VC set up for a link station on this port.
Parameter
Broadband Bearer Class
Valid Values
Class_A, Class_C, Class_X
Default Value
Class_X
Description
This parameter specifies the bearer class requested from the ATM network. The
classes are defined:
Class A
Constant bit rate (CBR) with end-to-end timing requirements
Class C
Variable bit rate (VBR) with no end-to-end timing requirements
Class X
Service allowing user-defined traffic type and timing requirements
APPN Configuration Commands
130 MRS V3.2 Protocol Config Ref Vol 2