beautypg.com

Appn configuration commands 148 – IBM SC30-3865-04 User Manual

Page 178

background image

Table 21. Configuration Parameter List - Port default LLC Characteristics (continued)

Parameter Information

Parameter

Receive acknowledgment timer (T2)

Valid Values

1 to 254 half-seconds

Default Value

1 half-second

Description

This parameter specifies the LLC receiver acknowledgment timer (T2) for all link
stations on this port.

The T2 parameter may be used with the N3 counter to reduce acknowledgment traffic.
A link station uses T2 to delay the sending of an acknowledgment for a received
I-format LPDU. T2 is started when an I-format LPDU is received, and reset when an
acknowledgment is sent in an I-format or S-format LPDU. If T2 expires, the link station
must send an acknowledgment as soon as possible. The value of T2 must be less than
that of T1, to ensure that the remote link station will receive the delayed
acknowledgment before its T1 expires.

Parameter

Acknowledgments needed to increment working window

Valid Values

0 to 127

Default Value

1

Description

When the working window (Ww) is not equal to the Maximum Transmit Window Size
(Tw), this parameter is the number of transmitted I-format LPDUs that must be
acknowledged before the working window can be incremented (by 1). When congestion
is detected, by the loss of I-format LPDUs, Ww is set to 1.

Table 22. Configuration Parameter List - HPR Override Defaults

Parameter Information

Parameter

Inactivity timer override for HPR (HPR Ti)

Valid Values

1 to 254 seconds

Default Value

2 seconds

Description

This parameter specifies the LLC inactivity timer (HPR Ti) that is to be used for all link
stations on this port supporting HPR when the HPR supported parameter is enabled on
this port. This default overrides the value of the default LLC inactivity timer (Ti)
parameter specified on the default LLC characteristics parameter.

APPN Configuration Commands

148

MRS V3.2 Protocol Config Ref Vol 2