IBM SC30-3865-04 - Manual (Page 361)

Area Address
Indicates addresses within the routing domain. The router can have a
maximum of three area addresses configured at any one time.
Change Metric
Use the change metric command to modify the cost of a circuit.
Syntax:
change metric
Example:
change metric
Circuit [0]?
New Cost [0]?
Circuit
Indicates the circuit number that you want to change.
New Cost
Indicates the new cost of the circuit. Range: 1 to 63.
CLNP-Stats
Use the clnp-stats command to display the OSI Connectionless Layer Network
Protocol (CLNP) statistics.
Syntax:
clnp-statistics
Example:
clnp-statistics
Received incomplete packet 0
Received packet with bad NSAP length 0
Received packet with bad checksum 0
Received packet with bad version number 0
Received packet with bad type 0
Received packet with expired lifetime 0
Received packet with bad option 0
Received packet with unknown destination 0
Received packet with no segmentation permitted 0
Received data packet cannot be forwarded 0
CLNP input queue overflow 0
No buffer available to send error packet 0
No route to send error packet 0
Received OK CLNP packet 0
Cannot forward error packet 0
IS0 unknown initial protocol ID 0
Received error packet 0
Received local data packet 0
Sent error packet 0
received echo packet - destination unknown 0
cannot send an echo packet, handler error 0
sent ECHO reply packet 0
sent ECHO request packet 0
received ECHO Request 0
received ECHO reply 0
Error PDU dropped - SP, MS or E/R flag set 0
Received incomplete packet
Indicates that a data packet fragment recognized as an ISO CLNP data
packet was received.
OSI/DECnet V Monitoring Commands (Talk 5)
Chapter 10. Configuring and Monitoring OSI/DECnet V 331