IBM SC30-3865-04 - Manual (Page 304)

Purge
Use the purge command to remove access control lists and routing filters from the
permanent database.
Syntax:
purge module access-control . . .
module routing-filter . .
module access-control circuit-specifier
Removes access control lists from the permanent database. You can delete
an entire access control list; you cannot delete one filter.
all circuits
Specifies all circuits on the router.
circuit name
Specifies the named circuit.
Example: purge module access-control all circuits
module routing-filter circuit-specifier
Removes routing filters from the permanent database. You can purge a
specified filter or you can purge them all.
The options for the circuit-specifiers include the following:
all Specifies all routing filters in the configuration memory.
circuit name
Specifies the routing filter for the named circuit.
Example: purge module routing-filter all
Set
Use the set command to add, set, or modify circuit specifiers, global arguments,
data link modules, or nodes in the volatile DNA database.
Syntax:
set circuit . . .
executor . . .
node . . .
For a description of the options for these arguments, see “Define/Set” on page 266.
Show
Use the show command to show the status of the volatile database and volatile
nodes in the routing database.
Syntax:
show area-specifier . . .
node-specifier . . .
DNA IV Configuration and Monitoring Commands
274 MRS V3.2 Protocol Config Ref Vol 2