IBM SC30-3865-04 - Manual (Page 115)

Table 4. Configuration Parameter List - APPN Routing (continued)
Parameter Information
Parameter
Enable branch extender or border node
Valid Values
0 (enable neither)
1 (enable branch extender)
2 (enable border node)
Default
0
Description
This parameter specifies whether branch extender function, border node function, or
neither will be enabled on this node. If either function is enabled, appropriate additional
questions will be asked.
Parameter
Permit search for unregistered LUs
Valid Values
Yes or No
Default
No
Description
This parameter specifies whether this node (when acting as an End Node) can be
searched for LUs even if the LUs were not registered with the network node server of
the Branch Extender. If
yes is specified, this node can be searched for LUs.
Note: This question is asked only if Enable Branch Extender or Border Node
parameter is set to
branch extender .
Parameter
Subnet visit count
Valid Values
1 — 255
Default
3
Description
Specifies the node level default for the maximum number of subnetworks that a
multi-subnetwork session may traverse. The default may be overridden as part of port,
link, or routing list configuration.
Note: This is the first of the questions asked only if border node has been enabled.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 85