IBM SC30-3865-04 - Manual (Page 346)

DTE address
Indicates the DTE address of the X.25 network to which you are
connecting or the DLCI of Frame Relay network to which you are
connecting.
routing-circuit routing-circuit-name
Removes an X.25 routing circuit that was established with add
routing-circuit from the permanent database.
Example:
delete routing-circuit p_system2
subnet intfc#
Removes a subnet that was previously configured with the set subnet
command.
Intfc# indicates the interface number of the configured subnet.
Example:
delete subnet 1
template template-name
Removes the template for a static outgoing routing circuit by which the
router generates outgoing X.25 messages from the permanent database.
Example:
delete template x25_5
virtual-circuit
Removes an X.25 or a Frame Relay virtual circuit that was previously
configured with the set virtual-circuit command.
Example:
delete virtual-circuit
Interface number [0]?
DTE address []?
Interface number
Interface number over which the virtual circuit is configured.
DTE address
DTE address of the X.25 network to which you are connecting or
the DLCI of Frame Relay network to which you are connecting.
Disable
Use the disable command to disable those features previously enabled using the
enable command.
Syntax:
disable osi
routing-circuit
subnet
osi Disables the OSI protocol on the router.
routing-circuit routing-circuit-name
Disables the specified routing circuit.
Use the add routing-circuit command to set up routing-circuits.
subnet interface#
Disables the OSI protocol on the specified subnet ( interface#).
DECnet V/OSI Configuration Commands (Talk 6)
316 MRS V3.2 Protocol Config Ref Vol 2