IBM SC30-3865-04 - Manual (Page 275)

number includes VINES servers and 2210s that are the first point-of-contact
after crossing a WAN. The range is 1 to 65535, and the default is 50.
Example: set service-node-neighbors 100
Accessing the VINES Monitoring Environment
To access the VINES monitoring environment,
* t 5
Then, enter the following command at the + prompt:
+ protocol vin
VINES>
VINES Monitoring Commands
This section describes the VINES monitoring commands. Enter these commands at
the
VINES> prompt.
Table 56. VINES Monitoring Command Summary
Command Function
? (Help) Displays all the commands available for this command level or
lists the options for specific commands (if available). See
“Getting Help” on page xxvi.
Counters Displays routing errors and the number of times the VINES
input queue was full when packets were received from the
specified interface.
Dump Displays the current contents of the VINES routing and neighbor
tables.
Route Displays an entry from the VINES routing table.
Exit Returns you to the previous command level. See “Exiting a
Lower Level Environment” on page xxvii.
Counters
Use the counters command to display routing errors and the number of times the
VINES input queue was full when packets were received from the specified
interface.
Syntax:
counters
Example: counters
Routing Errors
Count Type
----- ----
2 Net Unreachable
3 Hop Count Expired
3 Routing Update from Orphan Client
0 Routing Redirect Received
0 Routing Response Received
VINES Input Packet Overflows
Net Count
--- -----
Eth/0 5
Eth/1 1
VINES Configuration Commands (Talk 6)
Chapter 6. Configuring and Monitoring VINES 245