IBM SC30-3865-04 - Manual (Page 213)

Table 32. Configuration Parameter List - TG Characteristics (Connection
Network) (continued)
Parameter Information
Parameter
Third user-defined characteristic
Valid Values
0 to 255
Default Value
128
Description
This parameter specifies the third of three additional characteristics that users may
define to describe the TGs in the network. The default value of 128 allows a subset of
TGs to be defined as more or less desirable than the rest without defining values for all
TGs.
Syntax:
add mode
You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
Table 33. Configuration Parameter List - APPN COS - Mode Name to COS Name Mapping
- Detail
Parameter Information
Parameter
Mode name (required)
Valid Values
A string of 1 to 8 characters:
v First character: A to Z
v Second to eighth characters: A to Z, 0 to 9
Note: An existing mode name for an existing network, of which this router network
node is to become a member, using the special characters @, $, and # from the
character set A, continues to be supported; however, these characters should not be
used for new mode names.
Default Value
None
Description
This parameter specifies the Mode name for the Mode name to COS name mapping
being defined. See “COS Options” on page 38 for additional information about Mode
name to COS mapping.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 183