beautypg.com

IBM SC30-3865-04 User Manual

Page 294

background image

Note: This example is for configuring a router to interoperate with

other routers supporting the DEC-routing standard over X.25
networks. A router supporting the standard must be defined
as type DEC-ROUTING-IV (level 1) or DEC-AREA (level 2).
The default routing type is ROUTING-IV and AREA which
allows interoperation with many existing IBM 2210 and other
compatible routers.

NCP> define exec state on

Restart the router so that when you configure the X.25 circuit, all DEC
specific parameters are visible. To verify executor configuration,

NCP> show

executor characteristics

b. DEFINE PhaseIV X.25 circuits.

You must configure the X.25 circuit as either a PVC or SVC. If this circuit is
configured as a PVC then the other end must also be a PVC. If this circuit is
configured as an IN-SVC, then the other end must be configured as an
OUT-SVC

NCP> define cir x25/0 usage IN-SVC

NCP> define cir x25/0 DTE-address "remote X.25 DTE"

NCP> define cir x25/0 call-data

NCP> define cir x25/0 verification enabled

Enabling verification is optional.

c. DEFINE circuits to the active state:

v

for Token-Ring

NCP> define cir TKR/0 router type bilingual

v

for ALL circuits

NCP> define cir xxx state on

Restart the router so that all of the DECnet parameters become effective,
VERIFY the X.25 configuration within the DECnet protocol is as you want it.

NCP> list circuit x25/0 characteristics

Using DNA IV

264

MRS V3.2 Protocol Config Ref Vol 2