beautypg.com

Appn configuration commands – IBM SC30-3865-04 User Manual

Page 123

background image

Syntax:

set

dlur

You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].

Table 7. Configuration Parameter List - Dependent LU Requester

Parameter Information

Parameter

Enable dependent LU requester (DLUR) on this network node

Valid Values

Yes, No

Default Value

No

Description

This parameter specifies whether a dependent LU requester is to be functionally
enabled on this node.

Parameter

Default fully-qualified CP name of primary DLUS (required when DLUR is enabled)

Valid Values

A string of up to 17 characters in the form of

netID.CPname

, where:

v

netID

is a network ID from 1 to 8 characters

v

CPname

is a CP name from 1 to 8 characters

Each name must conform to the following rules:

v

First character: A to Z

v

Second to eighth characters: A to Z, 0 to 9

Note: An existing fully-qualified CP name, using the special characters @, $, and #
from the character set A, continues to be supported; however, these characters should
not be used for new CP names.

Default Value

None

Description

This parameter specifies the fully-qualified control point (CP) name of the dependent
LU server (DLUS) that is used by default. The default primary server may be
overridden on a link station basis. The default server is used for incoming requests
from downstream PUs when a primary DLUS has not been specified for the associated
link station.

APPN Configuration Commands

Chapter 2. Configuring and Monitoring APPN

93