beautypg.com

Appn configuration command detail, Enable/disable, Configuration parameter list - appn routing – IBM SC30-3865-04 User Manual

Page 113: Appn configuration command detail enable/disable

background image

APPN Configuration Command Detail

Enable/Disable

Use the enable/disable command to enable (or disable):

Syntax:

enable

appn

[or disable]

dlur

port

port name

Set

Use the set command to set:

Syntax:

set

node

You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].

Table 4. Configuration Parameter List - APPN Routing

Parameter Information

Parameter

Enable APPN

Valid Values

Yes, No

Default Value

Yes

Description

This parameter enables or disables the router as an APPN network node.

This parameter enables both APPN and HPR routing capability for this network node
which consists of defining the Network ID and CP name for this node. APPN, however,
must be enabled on the particular ports on which you desire to support APPN routing.
Additionally, support for HPR must be enabled on the particular APPN ports desired
and must be supported by the particular link stations on those ports.
Note: HPR only supported on LAN, frame relay and PPP direct DLC ports.

APPN Configuration Commands

Chapter 2. Configuring and Monitoring APPN

83