IBM SC30-3865-04 - Manual (Page 440)

+ p ndp
NDP>
NDP Monitoring Commands
This section describes the NDP monitoring commands.
Table 70. NDP Monitoring Command Summary
Command Function
? (Help) Displays all the commands available for this command level or lists the
options for specific commands (if available). See “Getting Help” on page
xxvi.
dump Displays routing tables.
ping6 Dynamically pings an IPv6 address.
list Displays the configuration.
Exit Returns you to the previous command level. See “Exiting a Lower Level
Environment” on page xxvii.
Dump
See “Dump routing tables” on page 416 for information about the dump command.
Ping6
See “Ping6” on page 402 for details about the ping6 command.
List
Use the list command to display the configuration. Only interfaces with RA
configured are displayed even though a prefix may exist in the prefix list on other
interfaces as a result of IPv6 address configuration.
Syntax:
list
Example:
NDP>list all
Router Advertisement for Interface 0 (PPP/0):
Hop RA Interval Rtr Reach Retrans
State M O LLA Limit Min - Max Lifetime Time Timer MTU
ENABLED N N Y 0 200 - 600 1800 0 0 0
Advertised Prefixes:
Prefix/Length On-Link Auto Valid/Preferred Life
NDP Configuration Commands (Talk 6)
410 MRS V3.2 Protocol Config Ref Vol 2
|
|
|
|
|
|
||
||
||
|
|
||
||
||
||
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|