IBM SC30-3865-04 - Manual (Page 311)

Area maximum cost = 1022
Area maximum hops = 30
Maximum buffers = 103
Buffer size = 2038
Example:
list executor status
This example shows the status of the router in the permanent database:
Node Permanent Status
Executor node = 2.26 (gato)
State = on
Type = DEC-area
Example:
show executor counters
This example shows the counters that DNA keeps.
Node Volatile Counters
Executor node = 2.26 (gato)
525948 Seconds since last zeroed
0 Aged packet loss
0 Node unreachable packet loss
0 Node out-of-range packet loss
0 Oversized packet loss
0 Packet format error
0 Partial routing update loss
0 Verification reject
The following items define the fields that are displayed when you use the
show/list executor command.
area maximum cost
Maximum allowed cost to an area.
area maximum hops
Maximum allowed hops to an area.
broadcast routing timer
Frequency of sending routing messages in the absence of any
changes.
buffer size
Buffer size for the router.
executor node
Node address and node name. The node name is the name set by
the CONFIG set hostname command.
identification
Identification of the router software, as sent in MOP System ID
messages.
maximum area
Highest area to which routes are kept.
maximum broadcast nonrouters
Maximum number of end-nodes that can be adjacent to this router.
maximum broadcast routers
Maximum number of routers that can be adjacent to this router.
maximum buffers
Number of packet buffers in the router.
maximum cost
Maximum allowed cost to a node.
maximum hops
Maximum allowed hops to a node.
DNA IV Configuration and Monitoring Commands
Chapter 8. Configuring and Monitoring DNA IV 281