IBM SC30-3865-04 - Manual (Page 453)

IPV6>traceroute
Destination IPv6 address []? 7::8
Source IPV6 address []? 6::9
Data size in bytes [56]?
Number of probes per hop [3]?
Wait time between retries in seconds [3]?
Maximum TTL [32]?
TRACEROUTE6 7::8: 56 data bytes
1 * * * *
IPV6>
See “Traceroute6” on page 402 for a description of the parameters.
Variables
Use the variables command to display information about the PIM configuration
variables.
Syntax:
variables
Example:
PIM6>v
PIM: on
Graft Timeout: 3 seconds
Assert Timeout: 210 seconds
PIM Unicast Metric Preferences (hex)
RIP FFFF Default FFFF
Direct FFFF Fixed FFFF
Filter FFFF
PIM6>
PIM: on/off
This indicates whether PIM-DM is currently enabled or disabled.
Graft Timeout
The number of seconds that grafts are retransmitted if no graft
acknowledgement has been received.
Assert Timeout
The number of seconds that assert information learned by upstream routers
is retained before reverting back to local routing information.
PIM Unicast Metric Preferences
Displays current configured routing type metric preferences. Each route
type supported is listed with a hex value displaying the currently configured
metric preference.
PIM Monitoring Commands (Talk 5)
Chapter 16. Configuring and Monitoring Protocol Independent Multicast Routing Protocol (PIM) 423
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|