IBM SC30-3865-04 - Manual (Page 308)

known circuits
Specifies all circuits on the router.
The following items are the subcommand options you select from after you
enter the command and the circuit specifier:
characteristics
Provides detailed information on all of the argument settings for the
circuit.
counters
Shows counters for the circuit.
status Shows detailed information on the circuit from the volatile database.
summary
Shows summary information on the circuit from the volatile
database. This is the default if no argument is supplied.
Example:
show all circuits
Circuit Volatile Summary
Circuit State Adjacent
Node
X25/0 on 5.25
Eth/0 on 1.22
Eth/0 2.14
Eth/0 1.13
PPP/0 off
Example:
list circuit eth/0 characteristics
Circuit Permanent Characteristics
Circuit = Eth/0
State = On
Cost = 4
Router priority = 64
Hello timer = 15
Maximum routers = 16
Router type = Standard
Example:
show active circuits status
Active Circuit Volatile Status
Circuit State Adjacent Block
Node Size
Eth/0 on 1.22 1498
Eth/0 2.14 1498
Eth/0 1.13 1498
X25/0 on 5.25 1498
Example:
show all circuits characteristics
This example shows the current characteristics of the circuits on this
machine. This includes all of the configuration arguments, as well as the
current adjacencies, and the Listen timer (three times the adjacency’s hello
timer).
Circuit Volatile Characteristics
Circuit = Eth/0
State = on
Designated router = 2.26
Cost = 4
Router priority = 64
Hello timer = 15
Maximum routers = 16
DNA IV Configuration and Monitoring Commands
278 MRS V3.2 Protocol Config Ref Vol 2