IBM SC30-3865-04 - Manual (Page 254)

Example:
ap2config>delete nfilter in
Interface # [0]? 1
Zone name []? Marketing
zfilter out interface# zone name
Deletes a zone name filter from the output of the interface.
Example:
delete zfilter out
Interface # [0]? 1
Zone name []? Marketing
interface
Use this command to delete an interface. This is the only way to delete
zone names that have non-printing characters.
Example:
ap2config>delete interface 1
Disable
Use the disable command to disable AP2 on all interfaces or on a specified
interface, checksumming, filtering, APL/AP2 translation, or split horizon routing.
Syntax:
disable ap2
checksum
interface . . .
nfilter in . . .
nfilter out . . .
zfilter in . . .
zfilter out . . .
split-horizon-routing . . .
ap2 Disables the AppleTalk Phase 2 packet forwarder for all interfaces.
Example:
ap2config>disable ap2
checksum
Specifies that the router will not compute the checksum in packets it
generates. The router usually checksums all packets it forwards. This is the
default.
Example:
ap2config>disable checksum
interface interface#
Disables all AP2 functions on the specified network interface. The network
continues to remain available for all other protocols.
Example:
ap2config>disable interface 2
nfilter in interface#
Disables, but does not delete, the input network filters on this interface.
AppleTalk Phase 2 Configuration Commands (Talk 6)
224 MRS V3.2 Protocol Config Ref Vol 2