beautypg.com

Is-adjacencies, Is-is-stats – IBM SC30-3865-04 User Manual

Page 366

background image

Sent redirect

An ESIS redirect packet was sent out the interface.

Timed out route

An ESIS hello route has timed out.

Unable to allocate resources for a new ES adjacency

An ES-IS hello packet was received but the router had insufficient
resources to establish an ES adjacency with the sending node.

hello PDU dropped, received over point-to-point circ

An ES-IS hello packet was dropped because the circuit involved is a
point-to-point circuit.

ESIS hello PPDU dropped, no matching area address

An ES-IS hello packet was dropped because the area did not match the
router’s area address. The ES-IS protocol applies to one area only.

dropped hello packet-manual ES adjacency exists.

An ES-IS hello packet was dropped because a static ES adjacency exists
with the sending node.

IS-Adjacencies

Use the IS-adjacencies command to list all the IS adjacencies that are learned
through the ISIS protocol.

Syntax:

is-adjacencies

Example:

is-adjacencies

Intermediate System Adjacencies

System ID

MAC Address

Int Level Usage

State

Life

Type

0000-9310-04C8

AA00-0400-EF04

0

L1

L1/L2

DOWN

OSI

0000-9310-04C8

AA00-0400-EF04

0

L2

L1/L2

DOWN

DNAIV

AA00-0400-0504

AA00-0400-0504

1

L2

L2

UP

5390

OSI

System ID

The system ID of the IS adjacency.

MAC Address

Indicates the MAC Address of the IS adjacency.

Int

Indicates the router’s interface number that connects to the IS adjacency.

Level

For LANs this indicates the neighbor system level from type of hello
message, L1 or L2. For point-to-point this indicates the neighbor system
type L1 only, otherwise L2.

Usage Indicates from the hello packet circuit type, L1 only, L2 only, or L1 and L2.

State

Indicates the operational state of the IS adjacency, up or down.

Life

Indicates the amount of time, in seconds, before discarding the last IS Hello
message.

Type

Indicates the routing protocol type of the IS adjacency, OSI or DNA IV.

IS-IS-Stats

Use the is-is-stats command to display information associated with the ISIS
protocol.

OSI/DECnet V Monitoring Commands (Talk 5)

336

MRS V3.2 Protocol Config Ref Vol 2