IBM SC30-3865-04 - Manual (Page 422)

automatic-tunnel-parameters
Specifies the tunnel parameter values for automatic tunnels that flow
through the router.
ttl value
Specifies the time-to-live value for the frames encapsulated for the
tunnel.
Valid Values:
Default Value: 64
allow fragmentation in tunnel?
Specifies whether the fragmentation in the tunnel will be allowed.
Specifying
yes allows fragmentation in the tunnel in case the IPv4
network that the tunnel is using does not provide enough
information to allow the device to return a “Packet Too Big”
message to the IPv6 host.
Valid Values: yes or no
Default Value: no
hop count
Specifies the hop count to be used on automatically tunnelled
packets.
Valid Values: 1 - 255
Default Value: 64
cache-size
Specifies the buffer size for the fast forwarding path cache.
number of cache entries
Specifies the number of entries in the fast forwarding path cache.
Valid Values: 64 - 10 000
Default Value: 64
default network-gateway
default gateway
Valid Values: Any valid IPv6 address
Default Value: none
gateway’s cost
Specifies the cost associated with this gateway.
Valid Values: 1 - 255
Default Value: 1
default subnet-gateway
for which subnetted network
Valid Values: Any valid IPv6 address
Default Value: none
default gateway
Valid Values: Any valid IPv6 address
Default Value: none
IPV6 Configuration Commands (Talk 6)
392 MRS V3.2 Protocol Config Ref Vol 2
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|