IBM SC30-3865-04 - Manual (Page 167)

Table 19. Configuration Parameter List - Port Definition (continued)
Parameter Information
Parameter
Percent of link stations reserved for outgoing calls
Valid Values
0 to 100
The sum of the percent of link stations reserved for incoming calls and the percent of
link stations reserved for outgoing calls cannot exceed 100%. If SDLC primary and
multipoint, then valid value is 100.
Default Value
0 If SDLC primary and multipoint, then default value is 100.
Description
This parameter specifies the percentage of the maximum number of link stations that
will be reserved for outgoing calls. Fractions resulting from the computation are
truncated. Link stations that are not reserved for incoming or outgoing calls are
available for either purpose on a demand basis.
Parameter
UDP port number for XID exchange
Valid Values
1024 to 65535
Default Value
11000
Description
This parameter specifies the UDP port number to be used for XID exchange and is
used during IP port definition. This port number must be the same as the one defined
on other devices in the network.
Parameter
UDP port number for network priority traffic
Valid Values
1024 to 65535
Default Value
11001
Description
This parameter specifies the UDP port number to be used for network priority traffic.
Parameter
UDP port number for high priority traffic
Valid Values
1024 to 65535
Default Value
11002
Description
This parameter specifies the UDP port number to be used for high priority traffic.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 137