IBM SC30-3865-04 - Manual (Page 179)

Table 22. Configuration Parameter List - HPR Override Defaults (continued)
Parameter Information
Parameter
Reply timer override for HPR (HPR T1)
Valid Values
1 to 254 half-seconds
Default Value
2 half-seconds
Description
This parameter specifies the LLC reply timer (HPR T1) that is to be used for all link
stations on this port supporting HPR when the HPR supported parameter is enabled on
this port. This default overrides the value of the default LLC reply timer (T1) parameter
specified on the default LLC characteristics parameter.
Parameter
Maximum number of retransmissions for HPR (HPR N2)
Valid Values
1 to 254
Default Value
3
Description
This parameter specifies the LLC maximum number of retransmissions (HPR N2) that
is to be used for all link stations on this port supporting HPR when the HPR supported
parameter is enabled on this port. This default overrides the value of the default LLC
maximum number of retransmissions (N2) parameter specified on the default LLC
Characteristics parameter.
Syntax:
add link-station
You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
Table 23. Configuration Parameter List - Link Station - Detail
Parameter Information
Parameter
Does link support APPN function
Valid Values
Yes or No
Default Value
Yes
Description
This parameter specifies whether this link station will support APPN function.
If the answer is no , questions concerning CP-CP sessions, security, encryption, CP
name, adjacent node type, branch extender, and extended border node will not be
asked and all of these functions will be disabled. Also, HPR will be disabled and no
HPR questions will be asked.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 149