IBM SC30-3865-04 - Manual (Page 187)

Table 23. Configuration Parameter List - Link Station - Detail (continued)
Parameter Information
Parameter
Preferred Network Node Server
Valid Values
Yes or No
Default Value
No
Description
This parameter indicates whether this uplink is to a network node server that is to be
used as the network node server for the node supporting Branch Extender function and
acting as an end node. If
yes is specified, this uplink will be used as the network node
server for this node.
This question will be asked only if:
v Enabled Branch Extender is yes,
v This station is a network node,
v Branch Uplink is yes , and
v CP-CP sessions are supported on this link.
Parameter
TG Number
Valid Values
If limited resource is Yes, valid values are 1 - 20. If limited resource is No and link type
is X.25 SVC, valid values are 0 - 20.
Otherwise, valid values are 0 - 20.
Default Value
If limited resource is Yes, default is 1. If limited resource is No, default is 0.
Otherwise, default value is 0.
Description
This parameter uniquely identifies a TG between adjacent nodes.
Parameter
Solicit SSCP session
Valid Values
Yes or No
Default Value
No
If the link station name is the same as the CP name, then the default is yes .
Description
This parameter indicates whether this link is to solicit SSCP sessions.
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 157
|
|