beautypg.com

Show/list, Dna iv configuration and monitoring commands – IBM SC30-3865-04 User Manual

Page 307

background image

Example:

show adjacent nodes status

This example shows the detailed routing information on all adjacent nodes.
Only nodes with one hop will be shown. The node type is known and
displayed for adjacent nodes only since this information is contained in hello
messages only.

Adjacent Node Volatile Status

Executor node

= 2.26 (gato)

State

= on

Physical address

= AA-00-04-00-1A-08

Type

= DEC-area

Node

State

Type

Cost Hops Circuit Next

Addr

Node

2.14 reachable routing IV

3

1

Eth/0

2.14

2.34 reachable routing IV

2

1

PPP/0

2.34

2.42 reachable nonrouting IV 2

1

PPP/0

2.42

1.22 reachable area

3

1

Eth/0

1.22

Show/List

Use the show circuit command to retrieve information on the current state of the
specified circuits from the volatile database. The list circuit command retrieves the
data that is stored in the permanent data base for circuits.

Syntax:

show

all

area

circuit . . .

executor . . .

known

argument

module

argument

node

argument

Syntax:

list

all

area

circuit

argument

executor

argument

module

node

argument

circuit-specifier

argument

Where the circuit-specifiers options are the following:

active circuits

Specifies all circuits that are currently on (per the volatile database).

all circuits

Specifies all circuits on the router.

circuit name

Specifies the named circuit.

DNA IV Configuration and Monitoring Commands

Chapter 8. Configuring and Monitoring DNA IV

277