IBM SC30-3865-04 - Manual (Page 391)

NHS allows shortcuts to ATMARP clients?: Yes
Cache Sizes
-----------
Resolution cache: 10000 entries
Server purge cache: 10000 entries
Server registrations cache: 10000 entries
Extension Usage
---------------
Use NHRP Forward transit NHS record client extension: No
Use NHRP Reverse transit NHS record client extension: No
Use Responder Address client extension: No
Use LANE shortcuts extension: Yes
List of NHRP IP exclude records
-------------------------------
# Address Mask
1 6.6.6.6 255.255.255.255
2 5.5.5.0 255.255.255.0
Disallowed router-to-router shortcuts for IP
--------------------------------------------
None
NHRP Advanced Configuration Commands
This section explains all of the NHRP advanced configuration commands as shown
in Table 63. Enter the commands from the
NHRP Advanced config> prompt.
Table 63. NHRP Advanced Configuration Command Summary
Command Function
? (Help) Displays all the commands available for this command level or lists the
options for specific commands (if available). See “Getting Help” on page
xxvi.
Add Adds an NHRP interface, exclude list, or disallowed R2R shortcuts.
Change Changes an NHRP interface, or changes a LANE shortcut interface
definition.
Delete Deletes an NHRP interface, exclude list, or disallowed R2R shortcuts.
List Displays the NHRP configuration.
Set Sets NHRP parameters.
Exit Returns you to the previous command level. See “Exiting a Lower Level
Environment” on page xxvii.
Add
Use the add command to add an explicit interface definition, an exclude list entry,
or disallowed router-to-router shortcuts.
Syntax:
add interface definition
exclude list
disallowed router-to-router shortcuts
interface definition
Adds an explicit interface definition to either enable or disable an NHRP
interface. If NHRP is disabled on a particular network interface, NHRP
NHRP Configuration Commands (Talk 6)
Chapter 12. Configuring and Monitoring NHRP 361