IBM SC30-3865-04 - Manual (Page 256)

ap2config>enable checksum
interface interface#
Enables the router to send AppleTalk Phase 2 packets over specific
interfaces.
Example:
ap2config>enable interface 3
nfilter in exclusive or exclusive interface#
Enables network input filters and controls how the filter is applied to the
interface. Inclusive forwards matches. Exclusive drops matches.
Example:
ap2config>enable filter in inc
Interface # [0]? 1
nfilter out exclusive or exclusive interface#
Enables network output filters and controls how the filter is applied to the
interface. Inclusive forwards matches. Exclusive drops matches.
Example:
ap2config>enable filter out exec
Interface # [0]? 1
split-horizon-routing interface #
Enables split-horizon routing on the interface. The default is enabled.
Example:
ap2config>enable split-horizon-routing 1
zfilter Enables zone filters assigned to an interface. Must specify if filter is “in” or
“out” and if the filter is inclusive or exclusive. Inclusive means that only
packets matching the filter will be routed. Exclusive means that all packets
matching the filter will be discarded.
Example:
ap2config>enable zfilter in inc
Interface # [0]?
Example:
ap2config>enable zfilter out exec
Interface # [0]? 0
List
Use the list command to display the current AP2 configuration. In the example, the
router is a seed router on interfaces 0 and 1
Note: The list command accepts an interface# as an argument.
Syntax:
list
Example:
ap2config>list
APL2 globally enabled
Checksumming disabled
Cache size 500
List of configured interfaces:
Interface netrange / node Zone
0 1000-1000 / 1 "SerialLine"(Def)
AppleTalk Phase 2 Configuration Commands (Talk 6)
226 MRS V3.2 Protocol Config Ref Vol 2